Key sheet detailing the procedure for measuring cylinder bore dimensions.
| Identifier | ExFiles\Box 87\2\ scan0238 | |
| Date | 15th October 1936 | |
| Levallois. Sr/VA2/ET.15.10.36. CYLINDER BORE DIMENSIONS. KEY SHEET. -------------------- Measurements are now taken by us in 5 places in the cylinder bores, as specially requested by GWH. {George W. Hancock - Head Chateauroux} The 5 places measured have been taken at "AA {D. Abbot Anderson} " - right angles to the crankshaft - and "BB" - parallel to the crankshaft, equaling 10 measurements in all. 1. "AA {D. Abbot Anderson} " & "BB" measurement taken .500" from face of mouth upwards 2. " " & " " " " 2.250" " " " " " 3. " " & " " " " 3.500" " " " " " 4. " " & " " " " 5.250" " " " " " 5. " " & " " " " .3125" " " " "Crown downwards" Upon reference to our standard sheet of "Report upon condition of cylinders" (Cylinder bore dimensions), a copy of which we attach, the above mentioned Nos. 1 & 2 measurements will figure in that part of the sheet reserved for the "mouth" dimensions. No.3 measurements will figure in the "Centre" and Nos. 4 & 5 measurements will figure in the "Crown". Please refer to sketch below, showing position of the five measurements, as mentioned above. In the past, we have only measured up cylinder bore in 3 "AA {D. Abbot Anderson} " and "BB" places, viz. .500" from face of mouth, and Centre of bore or 3.800" from "Crown" downwards, and at .500" from "Crown" downwards. Sr/VA | ||
From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).