Blueprint for a Clutch Intermediate Lever.
| Identifier | ExFiles\Box 5\6\ 06-page042 | |
| Date | 27th April 1925 | |
| OPERATION TABLE: No 1: USE FORGING F50026F No 1A: HEAT TREAT No 2: SAND BLAST No 2A: LIGHTLY GLAZE PLAIN SIDE No 3: SURFACE GRIND BOTH SIDES TO THICKNESS No 4: DRILL & REAM LARGE BOSS No 5: DRILL & REAM SMALL BOSS, MACHINE: M {Mr Moon / Mr Moore} /SPINDLE, TOOL: JIG, TOOL Nº: 31692 No 6: DRILL PIN HOLE No 7: REMOVE FORGING No & REMARK PIECE No, MACHINE: FITTERS BOTTOM ROW: SEE SLEEVE FOR CLUTCH PEDAL SHAFT DRAWING ANNOTATIONS: F5351S PIECE No. MARKED HERE SECTION ON 'AA {D. Abbot Anderson} ' SLEEVE PINNED AND BRAZED IN THIS END DRILL .1375 DIA REAM FOR .156 DIA TAPER PIN (1 in 48) WHEN IN POSITION — USE FORGING F50026F — TITLE BLOCK: REPLACE ALL COPIES OF THIS TRACING IN THE FOLLOWING DEPTS. DRAWN BY: S.C. TRACED BY: F.W. CHECKED BY: L.S. APPROVED BY: MHA LIMITS O.K. DATE: 27-4-25 USED ON: 20H SECTION: 7100 SCALE: 1/1 MACHINE ALL OVER OR WHERE MARKED THUS HEAT TREAT: BRINELL NO-228 TITLE: CLUTCH INTERMEDIATE LEVER. (`A` TYPE) DRAWN: STANTON MATERIAL: S/M. SPECIFICATION: 201C. Nº OFF: 1. | ||
From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).