Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Proposal to manufacture the Wraith III steering column using welding instead of brazing.

Identifier  ExFiles\Box 9\7\  07-page053
Date  17th April 1937
  
650

MEMORANDUM
Copy to
Lim/Eng'g
Chassis

E/HY.{Tom Haldenby - Plant Engineer}3/E.17.4.37.

WRAITH III - STEERING COLUMN.

It has been suggested by Mr. Hives that the outer tube of the Wraith III. steering column be built up by welding, and that this should be tried on the bury chassis.

In B.Sch.8133 herewith (prints sent to RYS.) we show a proposed method of building up this tube. Apart from the fact that we are a little doubtful whether this welded construction is as strong as the brazing process one, we still wonder whether the scheme will prove any cheaper. The finish of the top and of the tube has to be very high to accommodate either plating or enamelling. The bottom end of the tube will require to be ground after welding as it is a location face for a bearing.

We are asking the Cost Department to give comparative costs for the two constructions.

R/W.

ATT/E.SCH.8133.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙