From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Troubleshooting report on a faulty dynamo for a No. 4 Goshawk engine.
| Identifier | WestWitteringFiles\I\July1922\ Scan44 | |
| Date | 19th July 1922 | |
| R R 235 a (100 T) (S.F. 816 6-19) G 2460 ORIGINAL To EFC. from R.{Sir Henry Royce} c. to Wor.{Arthur Wormald - General Works Manager} By.{R.W. Bailey - Chief Engineer} c. to Mr. Brock. X.4383. RE. DYNAMO SENT FOR NO.4.GOSHAWK. X4333 Owing to the absence of the coloured wire scheme, and the ends of the wire not being permanently marked, we had to exercise some ingenuity to find the correct wires to put on the dynamo. This was done however before the dynamo was tested. On joining up, the machine did not excite itself and the fuse was found to be blown. After replacing the fuse, the cutout chattered, and the ammeter vibrated badly, coinciding approximately with the speed of the armature, and again the fuse blew. After another similar attempt it was concluded that there was a broken wire on the armature. On taking the dynamo down however it was found that the spaces between the commutator plates was blocked with carbon dirt, and possibly the surface of the commutator was not clean. After carefully cleaning out the gaps, the machine was re-erected and worked perfectly. In addition to this temporary fault, the ball bearing at the minor end appeared to rumble and to be slack. These appear to need carefully testing. I would like to warn the Production Dept. to use plenty of heat while pressing up the commutator, and every endeavour should be made to see that the commutator plates are firm. It might be desirable to run the commutators in an overheated condition at very much over the running speed, (1) | ||