From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Condition of chassis 93 NK after completing 15,447 miles.
| Identifier | ExFiles\Box 71\4\ scan0213 | |
| Date | 20th May 1925 | |
| Hotel de France, Chateauroux. Indre. France. GWH.{George W. Hancock - Head Chateauroux}2/Crn.20.5.25. To: "HS{Lord Ernest Hives - Chair}" From: G.W.Hancock. ---------------- Report on chassis 93 NK after 15,447 miles. Engine. Engine power good & smooth. Compressions even. Examination of pistons shews even lubrication, but on the heavy side. valves & fittings to E.2217.B. - these are O.K. We have ground in these valves twice during the test. There is already a fair amount of carbon deposit on piston heads. Modified cast iron choke valve in down take pipe to L.E.C. 2035 - we have had no trouble with this since our last report. Carburetter butterfly throttle E.73166/7/8 - this has stuck open on two occasions. We stated in our last report, that this was due to very fine sand getting on to spindle. We have verified this on dismantling carburetter. There is a very fine crack in the hot-spot induction pipe at the bottom corner close to flange where carburetter is bolted up. After cleaning butterfly spindle, we have had no further trouble with sticking. Controls to Sch.625 slight amount of slack has developed in these, but not excessive. We found the ball end on oil relay lever had worked loose. We have swelled out the end and tightened this up again. As previously stated, we are now using the hot-spot, & the drivers are of the opinion that the explosions are slightly worse now on retard than they were. Front engine suspension tube to L.E.C. 2027 - this is still quite O.K. modified throttle governor spring to Sch.632, using spring E.5925 - this is still operating satisfactorily. We have on this car a left & right hand coupling to this spring; the threads on one side of this have given way, we have had to fix it up temporarily. We believe this was put on for experimental purposes, and is not a production feature. Spring drive to Sch.628 - this appears from outside examination to be quite O.K. Magneto & dynamo drive to L.E.C. 2019 & 2028 - the fabric couplings have slightly deteriorated, otherwise the drive is O.K. Magneto has been dismantled, & we found the H.T. brush stuck right up in the holder, which has caused heavy sparking to the sector ring. Consequently, this has burnt rather badly. We also found the earthing brush broken. The magneto has been thoroughly cleaned & these brushes replaced. Water pump white metal packing washer E.70631 - this is still satisfactory. Housing of water pump appears to be O.K. Battery ignition - since cleaning the condensor connections & making this job O.K., the ignition points are in a very good condition. Please note that the bone grey fibre rubbing block T.2. was O.K. when we replaced the contact points. This necessarily means that this is not now on the car. Cover E.73134 for oil filter (oil relay system) - quite O.K. Filter taken out for examination & was found choked with dirt. We have cleaned this & refitted it. Oil relief valve unit - this is fitted up with springs as previously reported. We found that the main oil relief valve was not working satisfactorily, the valve seating not being very good. After making this O.K., | ||