From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Wiring, fittings and voltage control for the 'Peregrine II' project.
| Identifier | ExFiles\Box 60\3\ Scan180 | |
| Date | 2nd November 1932 | |
| RHC.{R. H. Coverley - Production Engineer} Hs{Lord Ernest Hives - Chair}/Wsr. WST X6092 BY/RD4/W.2-11-32. "Peregrine II". Wiring and Fittings : Voltage Control. When we fit a regulator unit to the dashboard we shall require a different layout of conduits. We have taken this opportunity of making them a little bigger,and we have examined the frame drilling and laid these out afresh in view of the various difficulties that have arisen. We attach hereto our L.O.P. D.100372 - Wiring and Fittings (4 Sheets),and blue prints of the following new parts are also attached :- D.100359. Support Angle. D.100360. Support Angle. D.100403. Conduit on Dash. D.100404. Conduit on Dash,L.H. D.100405. Conduit on Dash,R.H. D.100406. Conduit Bracket,L.H. D.100407. Conduit on Dash,VERTICAL,R.H. D.100408. Conduit Bracket,Centre. D.100413. Distn.Board to Dynamo Cable. D.100414. -ditto- D.100415. -ditto- D.100416. Main Switch to Motor Cable. D.100417. -ditto- D.100418. Starter Switch to Switchbox Cable. D.100361. Flexible Tube. D.100419. Wiring Diagram. D.100372. Layout of Conduits. This latter drawing not only shows layout of the conduits,but gives the drilling required and the piece numbers of all the nuts and bolts affected. The pieces which require patterns have already been instructed to the Pattern Shop. Referring to the Wiring Diagram,we show on there the Distribution Board and Cutout for use with Voltage Regulator to "D" Scheme 583. We appreciate that this may not be ready in time and,therefore, the standard Distribution Board and Cutout will be used in conjunction with a regulator unit made up experimentally,as on 19-EX. Will you please put three sets of these parts in hand. BY/RD. | ||