From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Potential improvements and standardization for 'R' series materials and components.
Identifier | ExFiles\Box 34\3\ Scan072 | |
Date | 11th February 1921 | |
R.R. 226A (100 T) (S.H. 798, 10-12-20) G.{Mr Griffiths - Chief Accountant / Mr Gnapp} 9947 X2641 To EP.{G. Eric Platford - Chief Quality Engineer} from By.{R.W. Bailey - Chief Engineer} Extract - By10/H11.2.21. X.2565, "R" SERIES MATERIAL. The following sections have been held in view of the possibility of the Experimental Dept. wishing to bring in improvements for the various sections on the above series. e.{Mr Elliott - Chief Engineer} Push button switch. X.2641 Main switch. X.3660. Actuating Box. ----------- Are we to proceed with the standard scheme as at present, with parallel circuits, or will the "Series" scheme be availa ble. f.{Mr Friese} Pistons. X.4146. ------- We would remind you that your original proposed to do away with liners under the cylinders by moving the position of the Gudgeon Pin Boss in the piston has never been standardised. It was put up for standardisation but turned down by CJ who insisted on completing the usual tests. Since that decision, although we have raised the matter from time to time, we have gone no further with the scheme. g.{Mr Griffiths - Chief Accountant / Mr Gnapp} Magnetos. X.430. X.4181. ---------- These are ordered to up 2200 chassis of the post-war programme, that is, approximately half way through "P" Series. The order office are holding back these in case the Experimental Department wish to adopt the improved Watford or some other magneto. Of course standardisation sheets will be required for all of the above items, and if there is no possibility of bringing in the parts referred to, for "R" series, we would like to know in order that we may release them to the Order Office who certainly will have to have them released in the near future from the point of view of obtaining material for the works. | ||