Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
High tension DC testing procedures for Redmanol coil cases at high temperatures.

Identifier  ExFiles\Box 39\3\  Scan282
Date  4th May 1927
  
To R.{Sir Henry Royce} from EFC.
c. BJ. FN.
c. Wor.{Arthur Wormald - General Works Manager} BY.{R.W. Bailey - Chief Engineer}
c. E.{Mr Elliott - Chief Engineer} DA.{Bernard Day - Chassis Design}
c. Mr. Brock.

X3573
X4079

HIGH TENSION D.C. TESTING OF REDMANOL
COIL CASES AT TEMPERATURES UP TO 100°C.

In regard to our EFC1/T29.4.27, we now give the results of some tests taken on half a dozen redmanol coil cases of the type at present going on production, the apparatus used for this purpose being that as described in the aforementioned note. These results will be found in my assistant's report PC.132, copy of which is attached.

On the basis of the results given in this report, a proposed form of Specification of Test for these coil cases is as follows :-

"Specification of Insulation Test at Temperature of Redmanol Coil Cases.

With the six-volt RR. trembler coil No.6162 operating on a voltage of from 5.5. to 5.75 volts, and with the coil cases to be tested with the two electrodes in position (the inner electrode connected to the H.T. D.C. supply, and the outer to earth) placed in the oven.

(1) With the supply switched on and the voltage measuring spark gap open so as to ensure that no sparks pass, and with no condenser connected external to the rectifying unit, the reading of the Weston galvanometer should be carefully noted, time being allowed to obtain a settled condition.

(2) With the supply still on, the spark gap should be gradually closed until a breakover just occurs, when the supply may be switched off, the gap measured, and the equivalent voltage computed.

(3) The ratio of the voltage so obtained to the reading of the galvanometer in microamperes should then, for an ambient temperature lying between the limit 15 to 25°C, not be less than that given in the following table :-

Contd.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙