Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Schemes for improving the lubrication of the 'SS' valve gear.

Identifier  ExFiles\Box 17\6\  Scan082
Date  1st February 1929
  
To R.{Sir Henry Royce} from E.{Mr Elliott - Chief Engineer}
c. to Sg.{Arthur F. Sidgreaves - MD} Hs.{Lord Ernest Hives - Chair} BY.{R.W. Bailey - Chief Engineer}

+7060
E1/M1.2.29.

'SS{S. Smith}' VALVE GEAR. X.7060
X.7090

With further reference to the lubrication of valve gear, especially under conditions when the car is started off from cold, we have two schemes for effecting some improvement - e.g. submerging the camshaft and tappets in oil, and flowing the relief oil from the pump over the valve gear.

A third scheme suggests itself if we carry the oil pressure out to the push rod end of the valve rocker.

The whole of the tappet and push-rod mechanism can be pressure lubricated without much trouble since the push rod is already a tube.

The weight of oil added to the moving parts would be inconsiderable since the bore of the tube is only about half its external diameter.

The oil escaping from the tappets and pushrod generally should run down and lubricate the cam face.

A practical difficulty would be the drilling of the central hole in the tappet, but this part might be built up from tube.

E

SEE ORIGINAL FOR SKETCH.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙