Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Issue with the change speed lever sticking on the gate.

Identifier  ExFiles\Box 82\5\  scan0042
Date  16th March 1937
  
Rm{William Robotham - Chief Engineer} Hdy{William Hardy} 200a

HOTEL DE FRANCE.
CHATEAUROUX. Indre.
France.
Rm{William Robotham - Chief Engineer}/GWH{George W. Hancock - Head Chateauroux}/IMW{Ivan M. Waller - Head of Chateauroux}/4/JAB. 16th March 1937.

To. Rm.{William Robotham - Chief Engineer}
c.c. Rm{William Robotham - Chief Engineer}/GWH.{George W. Hancock - Head Chateauroux}

3. B. IV.

Trouble was experienced on several occasions with the change speed lever sticking on the 1st & 2nd side of the gate, and it was necessary to give it a sharp jerk to get it across the gate.

This was found to be due to the guide pin not standing truly vertical and in line with the shaft due to it not being a good fit against the casting of the gate to which it is fixed by four 2 B.A. studs. This allowed the shoulder on the pin to foul when trying to enter the washer in the end of the gear lever shaft, and is illustrated on the sketch herewith.

Is there any reason why the pin should not be the same diameter all the way along? What is the reason for this shoulder?

A drain hole for the gate casting would be desirable.

Rm{William Robotham - Chief Engineer}
See E/Hdy{William Hardy} 3/HP2-4-37 Hdy{William Hardy}

Rm{William Robotham - Chief Engineer}/GWH{George W. Hancock - Head Chateauroux}/IMW.{Ivan M. Waller - Head of Chateauroux}
Franklin. Waller.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙