Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Design and manufacturing of an instrument board panel for RR and Bentley cars.

Identifier  ExFiles\Box 15\7\  Scan186
Date  18th February 1933
  
X.7530

E.{Mr Elliott - Chief Engineer} FROM DA{Bernard Day - Chassis Design}/EV.{Ivan Evernden - coachwork}
DA{Bernard Day - Chassis Design}/EV{Ivan Evernden - coachwork}1/M18.2.33.
X.7530.
X.5530.
X.4553.
X.4027.

C. to SG.{Arthur F. Sidgreaves - MD} WOR.{Arthur Wormald - General Works Manager} HS.{Lord Ernest Hives - Chair} BY.{R.W. Bailey - Chief Engineer} HDY.{William Hardy}

RR. & BENTLEY CARS.
re. INSTRUMENT BOARD PANEL.

We thank you for E1/HPL0233. and the attached prints of various suggestions for the central instrument board patch which we hope will be common to RR. and Bentley cars.

We agree that it is very difficult, and not altogether satisfactory, to arrange 5 instruments around the switchbox; the lighting by means of 2 lamps is not good.

We agree that we like the arrangement of the lower half of the blueprint marked II as it does permit of our returning to an oil pressure gauge for the dampers should we be forced to do so.

As this patch now contains a small clock we shall no longer need to incorporate the clock in the tachometer on Bentley.

With respect to the design, which we appreciate was not intended to be final we would venture to point out 1 or 2 features which our past experience has taught us something about.

It is essential that each individual instrument be capable of being removed from the instrument patch backwards without removing the patch from the board. This is forced on us by the thermometer and switchbox which have to go into the patch from the back as their connections cannot be broken at the instruments. We used a sort of communal clamp scheme on our own patch, and this has been modified to screws in the revised design by Smith & Sons.

It will be realised that it is very difficult to work on the back of the instrument board patch, and therefore we do not like to fasten the instruments in with a number of small screws or nuts.

We have some doubt as to the quality of the finish that will be obtainable on the face of the mount in the case of the patch as drawn, as this consists of a sheet metal pressing with punched holes and turned over bevels. We are of the opinion that in order to get the high finish that will be demanded, it will be necessary to use a thick metal plate as a mount, and for the holes and bevels to be machined.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙