From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Fitment, clearances, and proposed design alteration of the Goshawk undershield.
| Identifier | WestWitteringFiles\I\June1922\ Scan46 | |
| Date | 1st June 1922 | |
| To By- from E.{Mr Elliott - Chief Engineer} c. to SJ. c. to Wer. c. to Hs.{Lord Ernest Hives - Chair} ✓ c. to Ep.{G. Eric Platford - Chief Quality Engineer} [STAMP: ORIGINAL] [STAMP: RECEIVED] GOSHAWK - UNDERSHIELD CLEARANCES. X4272 We send you herewith drawing No. LeC 1593 dealing with the front end of the undershield. On the Goshawk here we find that the undershield was erected at the front end with the lip underneath the cross member, whereas it was intended to have been [handwritten: above] the bottom flange of the cross member, to avoid scooping in dust and mud. We can see on this particular car, owing to the peculiar shape of the front cross member that it is not possible to put the undershield up with the lip inside. We -have therefore made an alteration to the design which will in future simplify this job. The material of the undershield should now have no lap at this point, but a slight gap is shown on LeC 1593, and the undershield will then be independent of variations in the cross member. The cross member on the Goshawk here is not parallel: it measures 4.225 deep in the middle, and 4.075 at each end of the deep part, whereas it should be 4.250 parallel. There is also a very thick packing piece, .225 deep, put in where the cross member is fixed to the side channel. As the limits on the side channel of the cross member would be about .060 each for the depth dimensions, we expect that on production chassis the packing piece need not exceed a thickness of .125. We should like your opinion on this point. (1) | ||