From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
New method for lubricating the off-side bearing of the clutch operating shaft.
| Identifier | WestWitteringFiles\P\July1926-September1926\ Scan030 | |
| Date | 16th July 1926 | |
| TO BY.{R.W. Bailey - Chief Engineer} FROM AJS. Copy to - BJ. HS.{Lord Ernest Hives - Chair} ORIGINAL AJS2/M16.7.26. EAC. CLUTCH OPERATING SHAFT LUBRICATOR X8300 X8980 We send herewith LeC. 2264. shewing a method of lubricating the off-side bearing of clutch operating shaft in place of the scheme previously used, of putting some oil into the end of the shaft itself, which scheme Mr. Royce thinks inconvenient to use. The point we particularly wish reported upon with this scheme is whether oil will always reach the bearing satisfactorily by traversing the milled groove in the spindle. We would ask you to note that we do not ask for the groove to be of any special curvature, and only consider that it should have sufficient width, and extend far enough in plan view to catch the oil when the shaft is in any of the angular positions that it is likely to be due to clutch wear, and reach far enough into the bearing to carry oil where it is wanted. AJS. | ||