Rolls-Royce Archives
         « Prev  Box Series  Next »        

From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Design changes to the sloping footboard for the Bensport model.

Identifier  ExFiles\Box 179b\1\  img112
Date  12th October 1932
  
TO FROM DA{Bernard Day - Chassis Design}/RV. ORIGINAL
DA{Bernard Day - Chassis Design}/RV/12.10.32.
COPY TO HS.{Lord Ernest Hives - Chair}
FOOTBOARDS. BENSPORT.

We send herewith R.Sch.3563. showing the sloping footboard for the Bensport.

It will be noticed that the angle of the board to the horizontal has been increased so as to reduce the depth of the pot in the centre and to give more clearance for the tachometer drive. This has been made possible by the use of a single cast pedal gap plate permanently bolted to the dashboard and the dash bracket into which the bosses of the pedal plates can dip.

You will notice that very much more adequate gas excluding devices have been fitted around the pedal stems, and with little extra cost.

There is only one sloping board which is cut out to fit round and rest on this pedal gap plate. It is not attached by a catch as on previous cars but is held down with our standard floorboard screws going into the usual dashbracket dead-eye.

A design of the front floor and heelboard is to follow in a few days.

DA{Bernard Day - Chassis Design}/RV.
  
  


Copyright Sustain 2025, All Rights Reserved.    whatever is rightly done, however humble, is noble
An unhandled error has occurred. Reload 🗙