From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Instructions for mounting the Accessory Distribution Board, referencing drawing LeC. 2598.
| Identifier | WestWitteringFiles\T\2July1928-December1928\ Scan129 | |
| Date | 2nd October 1928 | |
| BY.{R.W. Bailey - Chief Engineer} FROM E.{Mr Elliott - Chief Engineer} Copy to BJ. " EFC. " HS.{Lord Ernest Hives - Chair} " DA.{Bernard Day - Chassis Design} ORIGINAL EAC.10. ACCESSORY DISTRIBUTION BOARD. X7740 We send you herewith drawing LeC. 2598., shewing the above. This is to be mounted on the engine side of the dash, either on an aluminium sub-base connected with the wiring conduits, or if these latter are on the rear face of dash it can be mounted direct with holes through for the conductors. In either case open ports or holes should be left available for the coachbuilders connections. This scheme will of course cancel any other provision for such connections. We would draw your attention to a modification shewn on this drawing to the fuse holders, which applies retrospectively to LeC. 2596. E.{Mr Elliott - Chief Engineer} | ||