From the Rolls-Royce experimental archive: a quarter of a million communications from Rolls-Royce, 1906 to 1960's. Documents from the Sir Henry Royce Memorial Foundation (SHRMF).
Listing technical prints and information provided in response to a request regarding a Turbo Transmitter.
| Identifier | ExFiles\Box 136\2\ scan0384 | |
| Date | 17th January 1944 | |
| To: Rm.{William Robotham - Chief Engineer} from Ev{Ivan Evernden - coachwork}/MGA.{M. G. Aspley} c. to Ev{Ivan Evernden - coachwork}/JD.{J. Draper - Frames} Ev{Ivan Evernden - coachwork}/MGA.{M. G. Aspley}2/HM.{Capt. W. Hallam - Head Repairs} 17.1.44 Turbo Transmitter. We enclose herewith the following prints, to provide the information requested by Turbo Transmitters in their letter of May 4th, 1942 :- (1) RG.{Mr Rowledge}171 3 sheets - Gearbox Casing. GB.4812 Bush - Servo Driving Shaft. GB.4814 Bearing and Cover - Speedo Drive Shaft. RG.{Mr Rowledge}463 Casing - Speedo Drive. RG.{Mr Rowledge}464 Driving Shaft - Speedo. GB.4830 Bracket - Tie Rod. RG.{Mr Rowledge}1913 Sheet 6 - Arrangement of Gearbox. (a) for the longitudinal position from the rear engine face to the Speedometer and Servo Drives. (b) for the bore, stud centres and general design of the position of the gearbox housing the speedometer drive. (c) for the position and general design of the facing to which the tie rod bracket is attached. (d) for the longitudinal dimension to the rear facing of the gearbox. (e) for the diameter and design of the near side bearing in the Servo Shaft. (f) for the position and design of the facing to which the fulcrum bracket E.78412 is fastened. (2) RG.{Mr Rowledge}1913 sheet 3 - Arrangement of Gearbox. RG.{Mr Rowledge}193 3rd. Motion Shaft. GB.4879 Coupling Flange. (a) for the design of the spline and method of bolting and locking the rear driving flange. (b) for the bolting of the flywheel and relationship of crankshaft flange. (3) RG.{Mr Rowledge}1913 sheet 7 - Arrangement of Gearbox. GB.4937 Packing Piece - Change Gear Gate. GB.4939 Change Gear Lever. GB.4940 DC. Bracket - Change Gear Gate. (a) for the operation of the reverse light switch. (b) for particulars of the change speed gate gas tight joint. Ev{Ivan Evernden - coachwork}/MGA.{M. G. Aspley} | ||